We will need the materials mentioned below: So let’s get started! Materials Requiredīefore starting with steps to program Blue Pill STM32, I will enlist the material required. We can use this experimental bootloader to program Blue Pill STM32 with Arduino IDE. Fortunately, there exists an experimental bootloader by LeafLabs developed for MapleMini boards.
To program Blue Pill STM32 directly from USB, we will flash Arduino Bootloader in it. So, we can not program a new STM32F103C8 development board through Arduino IDE. Unfortunately, the STM32F103C8 development board doesn’t come with an inbuilt Arduino bootloader. Also, we need a serial programmer all the time when we have to program the Blue Pill. Programming a Blue pill through an external programmer is a very hectic task. Hence Blue Pill is also considered as an alternative to Arduino.Īs we mentioned earlier, there are two ways of programming Blue Pill. There are some more noticeable differences where Blue Pill leads the Arduino. Also, it has 16 bit ADC while Arduino has a 10 bit ADC. STM32F103C8 (Blue Pill) has a higher number of pins as compared to Arduino Nano and Arduino UNO. To program Blue Pill STM32, we have two options, we can program it through an external programmer or directly by onboard micro USB port. Which makes it more efficient than Arduino. STM32F103C8 microcontroller is based on ARM cortex M3 architecture. Blue Pill STM32 (STM32F103C8) is one of them. Nowadays, there are some alternatives for Arduino as well. Arduino is the most used and preferred micro-controller board since its development.
0 kommentar(er)
